| ||
| A-760x | 2 Channel THX Mega Muscle Power Amp 380 W into 8,
| $1499.95 SOLD OUT |
|---|
In setting out to design the A-760x Carver's engineering team drew on lessons learned in the design and building of the acclaimed Lightstar Reference amplifier, a development hailed recently in "Fi" magazine as "evidence that Carver Corporation has made a strong commitment to first-rate build quality as well as to engineering innovation." The A-760x uses Carver's newest power amplification technology "Magnified Current". This technology enables the A-760x to provide either twice the continuous voltage or twice the continuous current needed by the loudspeaker load at any given time. With more than enough current and voltage-peak or continuous- the Lightstar-inspired A-760x is the ultimate consumer amplifier on the market today.
Specs:
A-760x FEATURES
Certified by Lucasfilm, Ltd. for use in home THX audio systems Magnified
Current technology for increasing voltage and current capability Total Direct
Coupling for high damping factor at all frequencies
Each channel protected by: individual fusing, excess temperature sense,
DC fault sense, power-on delay, shorted load sense.
Minimal signal path design, with on card I/O connectors eliminating internal
interconnect cables
Gold Plated RCA Jack Connections Dual analog lighted meters with range selection
switch
Meter light On/Off switch
Individual calibrated level trim controls for each channel
Removable handles for 17" cabinet space (with trim caps)
Designed and built by Carver Corporation in Lynnwood, WA USA
A-760x SPECIFICATIONS
Frequency Repsonse: 20-20kHz +0,-0.2dB
Power Output: FTC 20hz-20khz 8ohm 380 watts per channel
4ohm 600 watts per channel 2ohm 1150 watts per channel
Bridged mono power output: 1200 watts into 8 ohms
THD: less than 0.08%
Dynamic Headroom: >1.0dB @ 8ohms both channels driven
Gain: 29.0 dB (+/- 0.5dB)
Input Impedance 47 kohms
Damping Factor: >150 typical (20hz-20 khz)
| Model | Description | Price |
|---|---|---|
| A-500x | 2 Channel THX Mega Muscle Power Amp 250W into 8, Analog backlit meters, Bridges to mono. Dual Analog backlit meters. Made in Washinton |
FEATURES
Certified by Lucasfilm, Ltd. for use in home THX audio systems
Magnified Current technology for increasing voltage and current capability
Total Direct Coupling for high damping factor at all frequencies
Each channel protected by: individual fusing, excess temperature sense,
DC fault sense, power-on delay, shorted load sense.
Minimal signal path design, with on card I/O connectors eliminating internal
interconnect cables
Gold Plated RCA Jack Connections Dual analog lighted meters with range selection
switch
Meter light On/Off switch
Individual calibrated level trim controls for each channel
Removable handles for 17" cabinet space (with trim caps)
Designed by Carver Corporation in Lynnwood, WA USA
A-500x SPECIFICATIONS
Frequency Repsonse: 20-20kHz +0,-0.2dB
Power Output: FTC 20hz-20khz 8ohm 250 watts per channel
4ohm 400 watts per channel
2ohm 750 watts per channel
Bridged mono power output: 800 watts into 8 ohms
THD: less than 0.08%
Dynamic Headroom: >1.0dB @ 8ohms both channels driven
Gain: 29.0 dB (+/- 0.5dB)
Input Impedance 47 kohms
Damping Factor: >150 typical (20hz-20 khz)
| Model | Description | Price |
|---|---|---|
| 2 Channel Power Amp 110W into 8 Ohms, Analog backlit meters, Bridges to mono |
110W x 2 at 8 ohms, 20Hz to 20kHz
less than 0.03% THD at 1kHz
two channel stereo or bridged mono mode switch
all discrete circuitry throughout
Left/right level controls
Made in USA
dual analog power meters
meter range switch
dimensions 4.8"H x 19"W x 15.3"D
shipping weight 33Ibs.
| Model | Description | Price |
|---|---|---|
| 2 Channel slim-line Power Amp 70 W into 8, 120 W into 4, 200 W mono, 1 rackspace slim-line design, no meters, dual input level controls and line-level outputs just like the TFM 15 |
70W x 2 at 8 ohms, 20Hz to 20kHz
less than 0.02% THD at 1kHz
two channel stereo or bridged mono mode switch
all discrete circuitry throughout
Left/right level controls
a/b speaker selector
dimensions with handles 1.7"H x 19"W x 12.5"D
dimensions without handles 1.7"H x 17"W x 11.2"D
shipping weight 16 Ibs.
Model | Description | Price |
|---|---|---|
| CT-5.1x | AC-3/THX/Dolby Pro Logic PreAmp/Tuner on screen display, 7 audio inputs, 3 composite, 3 S-Video inputs, Dual Zone Home Theater. DTS upgradeable with future adapter. Two zone capable! | |
| NEW! AC-3/Dolby Pro Logic PreAmp/Tuner on screen display, 7 audio inputs, 3 composite, 3 S-Video inputs, Dual Zone Home Theater. DTS upgradeable with future adapter. Two zone capable! | ||
| American Made AC-3 adapter Upgradeable to DTS |
The CT-5.1x is a high performance Two zone capable control center
designed
with the experience and knowledge of a long line of quality Carver separates.
In addition to Dolby Pro Logic surround sound with adjustable delay and
five surround modes, the preamp/tuner design incorporates Carvers exclusive
Infinite Decorrelation which expands the critical rear soundstage beyond
the confines of the listening room. The features offered by the CT-5.1x
were carefully selected to provide the flexibility required for a surround
sound system, but not so complicated to make it difficult to understand
and operate. This preamp/tuner will provide uncompromising audio performance
from every channel.
FEATURES:
Two zone capable!
3 audio inputs, 2 composite video input,1 composite video output
Bass and treble controls
Digital synthesis AM/FM tuner section
16 tuner presets
Infinte Decorrelation for wider rear soundstage
Gold Plated RCA Jack Connections Remote Control
Dolby Pro-Logic surround with 5 modes and adjustable delay
Phono Input Stage
Two AC outlets one switched and one unswitched
Removable handles for 17" cabinet space (with trim caps)
Motor-driven Volume control can be operated from the remote control
Designed by Carver Corporation in Lynnwood, WA USA
SPECIFICATIONS (preamp section)
Frequency Repsonse 10-50kHz +/- 3dB
Signal to Noise Ratio 91db (bypass)
S/N MM Phono A-Weighted > 74dB
Input Sensitivity for 0.5V 85mV
Input Impedance 50 kohms
Sensitivity for 0.5V phono 1.4mV
Model | Description | Price |
|---|---|---|
| CT-25.1 | Dolby Pro Logic PreAmp/Tuner, AC-3 upgradeable, 3 audio inputs, 2 composite video input,1 composite video output | |
| CT-26v | Dolby Pro Logic PreAmp/Tuner with Theater Holgraphic circuitry. |
The CT-26v is a high performance control center designed with the experience and knowledge of a long line of quality Carver separates. In addition to Dolby Pro Logic surround sound with adjustable delay and five surround modes, the preamp/tuner design incorporates Carver's exclusive Infinite DecorrelationTM which expands the critical rear surround soundstage beyond the confines of the listening room. The features offered by the CT-26v were carefully selected to provide the flexibility required for a surround sound system, but not so complicated to make it difficult to understand and operate. This preamp/tuner will provide uncompromising audio performance from every channel.
Dolby Pro Logic surround with 5 modes and adjustable delay
Phono Input Stage
Infinite DecorrelationTM for a wider rear soundstage
3 audio inputs, 2 audio/video inputs, 1 composite video output
Digital frequency-synthesis AM/FM tuner
Random presetting of up to 16 AM/FM stations
Gold-plated RCA input jacks
Easy-to-read fluorescent display lets you confirm settings at a glance
Bass and treble tone controls and balance control
Motor-driven master volume control can be operated from the remote control
Two AC outlets, one switched and one unswitched
Infrared remote control
Removable handles for placement in 17" wide cabinet space (with trim
end caps)
3 audio inputs, 2 audio/video inputs, 1 composite video output
Infinite DecorrelationTM
phono input
subwoofer output
16 tuner presets
pre-programmed RC-5 remote control
dimensions with handles 4.65"H x 19"W x 13.5"D
dimensions without handles 4.65"H x 17"W x I I.5"D
shipping weight 16 lbs.
|
|
|
| CM-2002 | NEW! Integrated Amplifier 105W x 2 into 8 ohms. Descrete High Current Design, Sonic Holography, Co-axial Digital Input, Pre-Out/ Main in, Phono w/MM & MC. | $899.95 SOLD OUT |
|---|
|
|
|
| HTR-885.1 | NEW! 5.1 Channel Dolby Pro LogicAC-3/DTS ready Receiver 80 W x 3 / 30 W x 2 into 8 ohms. Descrete High Current Design on all 5 cannels. Infinate Decorrelation for wider rear channel sound stage. (for more info see below) | SOLD OUT |
|---|
The HTR-885.1 is Dolby digital ready. It's a high performance receiver built to the sonic standards of Carver separates. Its clean functional appearance belies the host of features and innovative audio technologies contained within its precision-crafted chassis. In addition to Dolby Pro Logic surround sound with adjustable delay and four surround modes, the receiver design incorporates Carver's exclusive Power SteeringTM which directs unused power where the audio signal requires it, and Infinite Decorrelation which expands the critical rear surround soundstage beyond the confines of the listening room. The five fully discrete bipolar amplifiers provide a pure, uncompromising audio performance from every channel.
Dolby Digital /5.1 Ready using DB-25 input port for AC-3 or DTS decoder
Dolby Pro Logic surround with 5 modes and adjustable delay
Exclusive Power SteeringTM circuitry provides over 50% more power on demand
for selected amplifier channels
80 watts x 3 front channels, 30 watts x 2 rear channels
Discrete high-current amplifier design on all 5 channels
Phono Input Stage
5-way binding post outputs on all channels
Infinite Decorrelation for a wider rear soundstage
3 audio inputs, 2 audio/video inputs, 1 composite video output
Digital frequency-synthesis AM/FM tuner
Random presetting of up to 16 AM/FM stations
Gold-plated RCA input jacks
Easy-to-read fluorescent display lets you confirm settings at a glance
Bass and treble tone controls and balance control
Motor-driven master volume control can be operated from the remote control
Two AC outlets, one switched and one unswitched
Remote control
Removable handles for placement in 17" wide cabinet space (with trim
end caps)
Designed by Carver Corporation in Lynnwood, WA USA
80W x 3 (front), 30W x 2 (rear) at 8 ohms, 20Hz to 20kHz
loss than 0.08% THD
Power Steering design (>120 W/ch)
3 audio inputs, 2 audio/video inputs, I composite video output
subwoofer output
Infinite DecorrelationTM
16 tuner presets
pre-programmed RC-5 remote control
dimensions with handles 6.63"H x l9"W x 13.5"D
dimensions without handles 6.63"H x 17"W x l l.5"D
shipping weight 25 lbs.
Features:
BiDAC D/A converters
Digital Time Lens circuitry
3 beam laser pick up
3 random play modes
3 repeat modes
RC-5 remote control
Multi-disc programming capability
digital output
dimensions with handles 4"H x l9"W x 16.75"D
dimensions without handles 4"H x 17"W x l5.5"D
shipping weight 18 Ibs.
Model | ||
| CT-24 | PreAmp/Tuner with advanced sonic holography and phono stage. Excetional performance for the money. Very Limited! | $499.95 SOLD OUT |
|---|
| ||
| AL-III Plus | Newly Re-engineered! Ribbon-Hybrid Full-Range Loudspeakers 48" ribbon crossed over at 150Hz to 10" down firing sealed woofer | $2000/pr SOLD OUT |
|---|---|---|
Four 10" Tower Mounted Woofers, 500W Lightstar Subwoofer Amp, Constant Directivity Tweeters, Bipolar design, Dipole Rear Speakers, Built-in bass management system, X-over Bypass |
